Skip to content

How to Build a Smok Pen

Written by

adams530

How to Build a Smok Pen

The Smok Pen is really a revolutionary vaporizing pen that allows for a write-to-write experience, whilst you are away from home. This is due to the unique design of the pen. It has two tanks, one smaller compared to the other, that house the e juice and charged batteries. Once the user really wants to write, he just places the pen in to the smaller tank and places the ink in the chamber where it’ll be vaporized. He simply turns on the pen and writes as though he could be writing under a black mirror.

smok pen

One of the biggest attributes of the Smok Pen is its ability to charge while it is on your desk. The reason being the coils on the Smok Pen were created in a way to help keep the e juice from dripping onto the table or somewhere else. This is due to the 0.3-ohm coil that’s placed in the Smok Pen. The 0.3-ohm coil means that even the slightest of air currents will not affect the writing process. The reason being the electronic circuitry has protection built in so that it will never be suffering from extremely low voltage electric currents.

The Smok Pen can be charged internally with a charger or via the USB connection that vapinger.com is included with it. Since the electronic circuitry has a safety barrier built in, this means that there is absolutely no risk involved when charging the device through the computer. The Smok Pen has a charging capacity of sixteen 50 mah batteries, that is ideal for all pens that use a couple of batteries.

In order to keep the Smok Pen doing work for an extended time period it is important you don’t overcharge the battery. Overcharging the battery will reduce the voltage that’s available and may eventually result in these devices malfunctioning. Overcharging the Smok Pen could also affect the vaporizing process. In the event that you feel that your battery is not getting the vapor it should, remove the pen from the power source and let it cool down for a few minutes.

The fire button on the Smok Pen is situated at the bottom right corner of the device. The fire button comes with an orange light, which indicates that it’s on. You can press this button to activate the electronic heating element that may let you vaporize the oil. Once you have done so you can take away the coil from the holder and stick it in to the holder and place the Smok Pen in to the airflow chamber, which will cause the heating element to start out heating up and burning off the wick.

When the coil is removed from the holder the airflow chamber is ready for the sub-ohm cartridge. The coils are placed inside the holder and they get heated from the airflow. After they get hot they begin to turn blue, which is the indication that it is ready for the pen’s battery. Make sure that you place your sub-ohm into the chamber before you push the fire button. If you don’t put the coil in to the airflow chamber then the oil will leak and cause the leaking of e-juice.

Before you put the battery into the pen, you must ensure that you have disconnected each of the leads. Then you have to remove the Smok Pen’s cap and locate the leak or drip tip. You must clean this with a small cotton bud, to be able to eliminate leak. Then reattach the cap back to the Smok Pen and you also will be ready to place the battery in to the pen.

The ultimate area of the construction process may be the adapter plate, which fits into the Smok Vaporizer’s USB port. This plate enables you to charge your e-juice during your computer, as long as you have an adapter for USB connection. I really like this part since it allows me to charge my entire kit at once without fretting about running out of power or constantly running out of e-juice.

Previous article

Vaping Juice for Teens

Next article

Dangers of Vaping - Could it be Really Dangerous?